High Speed Pulse Dial—Make Width
Specifies
the minimum length of the make signal in a high speed pulse dial.
High Speed Pulse Dial—
Pulse
% Break on this screen determines the value that can be specified here.
Default
20 ms
Value Range
4 ´ n (n=3–15) ms
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Pulse Type
Selects the type of pulse dial transmission appropriate to your area.
Default
Normal
Value Range
Normal, Sweden
, New Zealand
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Option Card Equipment—Option 1 and Option 2
Indicates the type of the card that is installed on the LCOT card (reference only).
Default
Not applicable
Value Range
None, Caller ID Card
, Pay Tone Card
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
PC Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port—
Caller ID Detection
Document Version 2016-03 PC Programming Manual 433
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
To Next Page
Loading...
