Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Feature Manual References
4.1.3 Caller ID
Caller ID—Caller ID (FSK) END Detection
Selects the method used to detect the end of Caller ID information.
Default
Length + Timer
Value Range
Length + Timer, Timer
Maintenance Console Location
9.24 PBX Configuration
—[1-1] Configuration—Slot—Card Property - LCO type
Feature Manual References
4.1.3 Caller ID
Caller ID—Caller ID (FSK) Header Examination
Enables the PBX to check the header of received Caller ID information. To enable this setting, Caller
ID—Caller ID Signaling on this screen should be set to FSK.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
9.24 PBX Configuration
—[1-1] Configuration—Slot—Card Property - LCO type
Feature Manual References
4.1.3 Caller ID
Caller ID—Caller ID (FSK) Detection Start Timer
Specifies
the length of time that the PBX waits before attempting to detect Caller ID information, after receiving
a call. To enable this setting,
Caller ID—Caller ID Signaling on this screen should be set to FSK.
Default
80 ms
Document Version 2016-03 PC Programming Manual 435
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
To Next Page
Loading...
