PG Drives Technology R-NET OMNI - Page 102

PG D RIVES T ECHNOLOGY O MNI – A DVANCED -P ROGRAMMING
SK78813/5
102
1 Decide which Profiles are to be associated with each Input Device
and set the parameter Input Device Type accordingly.
2 Set the parameter Profile Enable to enable only the required Profiles.
3 Ensure the parameter Mode Enable is set to enable the required
Modes for both Input Devices.
4 Decide upon appropriate names for each of the Profiles and set the
parameter Profile Name accordingly.
Example:
Example:Example:
Example:
It is required that a standard JSM controls Profiles 1 to 3 and that the Omni
controls Profiles 4 to 6. All Modes can be controlled via either of the Input
Devices and the Profiles are to be named: JSM Slow, JSM Medium, JSM Fast,
Omni Slow, Omni Medium and Omni Fast.
1 Set the Input Device type parameter for each of the relevant Profiles.
2 Disable Profile 7, as it is not required. There is no need to disable
Profile 8, as it is reserved for use by an Attendant type device.
3 Enable all Modes in the first Omni Profile.
4 Set the Profile names.
The Omni should now be programmed to suit the user and the SID, as
explained in the Standard section.