PG D
RIVES
T
ECHNOLOGY
O
MNI
– W
ARNING
S
UMMARY
SK78813/5
2.13 PM Memory Error
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT
control systems. Incorrect programming could result
in an unsafe set-up of a wheelchair for a user. PGDT
accept no responsibility for losses of any kind if the
programming of the control system is altered from
the factory pre-set values. Chapter 5 section 3.1.8.
2.14 User Switch Detached
Because a disconnected User Switch means there is
no emergency stop function, PG Drives Technology
recommend that Switch Detect is this option is
always set to On. PG Drives Technology will accept
no liability for any losses resulting from any other
setting of this parameter. Chapter 5 section 3.2.4.
2.15 Basic Tests
These tests are a minimum recommendation only. It is
the responsibility of the service person(s) to perform
other tests relevant to the original trip and wheelchair
type are carried out. Refer to the wheelchair’s
Technical Manual for exact information of other tests.
PGDT accept no liability for losses of any kind arising
from the carrying out of the described tests, or
from not carrying out additional relevant tests.
These tests should be conducted in an open space
and a restraining device such as a seat belt should
always be used. PGDT accepts no liability for losses
of any kind arising from failure to comply with this
condition. Chapter 5 section 4.
To Next Page
Loading...
Need help?
General
