PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- I
NSTALLATION
SK78813/5
10 Program the R-net Driving Characteristics to
Suit the User
Now that the Omni has been programmed to suit the SID, the powerchair’s
drive performance must be programmed to suit the individual user. By using
one of the methods explained in the section How to set up the Omni, the
powerchair’s speeds, acceleration rates and braking rates can be adjusted to
meet exact requirements. Refer to the user guide for the programming method
you are using for further details of the available adjustments. While conducting
this programming you may also need to refer to the previous section
Programming the Omni to Suit the User. It is recommended you read that
section before undertaking any programming.
Before test driving the system ensure there is sufficient space in which to drive
the wheelchair, and that you and the user understand how to stop the
wheelchair quickly.
Firstly, refer to the operating instructions for the type of SID in use. Ensure that the
user fully understands each SID command. It is advisable to initially select the
lowest speed setting and allow the user to become familiar with the controls
before increasing the setting.
The Omni also contains a training function, whereby any of the SID’s directional
commands can be disabled. For example, the left and right commands could
be disabled, in order to allow the user to become familiar with driving forwards.
Refer to the Programming Chapter for more details.
Select values that are comfortable and safe for the
powerchair user. It is the responsibility of the
healthcare professional to ensure these values are
comfortable and safe. PGDT accept no liability for any
losses resulting from unsuitable values.
To Next Page
Loading...
Need help?
General
