PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- O
PERATION
SK78813/5
An operation of the User Switch or a Right SID command while Exit is highlighted
exits to the point set by the parameter, Return To. For more details of this
parameter, refer to the section Return To in the Programming chapter.
If User Control is set to Sequence, then selecting the Exit option will sequence to
the next available menu entry.
10 Latched Operation
The programming for latched operation is now contained within the standard R-
net programming, with the Omni and or a standard JSM.
Within the standard R-net Programming, the relevant parameters are: Latched
Drive, Latched Actuators, Latched Timeout and Latched Timeout Beep. Refer to
the user guide for the programming method you are using for further details of
these parameters and latched operation.
11 LCD Screen Details
Some of the information in this section will have been covered earlier, however,
the following provides a complete description of all the LCD screen graphics.
The LCD screen is split into 3 areas of information. The Top Bar, the Base Bar and
the Main Screen Area.
Each area is covered separately within this section.
To Next Page
Loading...
Need help?
General
