PG Drives Technology R-NET OMNI - 1.2 Handheld Programming; 1.3 PC Programming

PG D RIVES T ECHNOLOGY O MNI – S TANDARD - P ROGRAMMING
SK78813/5
74
Position 3 Select
Position 4 Select
Position 5 Entry
l
Position 16 Entry
Beeps
BeepsBeeps
Beeps
Profile Change* Short
Mode Change* Short
User Menu Entry* Short
Menu Scroll* Short
Profile Id#* Off
Axis Id# * Off
Position 1* 0
|
Position 16* 0
P
PP
Port 2
ort 2ort 2
ort 2 All Parameters as per Port 1
All Parameters as per Port 1All Parameters as per Port 1
All Parameters as per Port 1
Settings
SettingsSettings
Settings
Set Time Current Time
Display Time 24Hr
Backlight 100%
Background Auto (Available mid-2007)
Training
TrainingTraining
Training Mode
ModeMode
Mode
Fwd Inhibit No
Rev Inhibit No
Left Inhibit No
Right Inhibit No
1.2 Handheld Programming
From 2008, the Omni will be programmable via the R-net Handheld
Programmer. Refer to the R-net Handheld Programmer user guide for further
details of how to program using this method.
1.3 PC Programming
The Omni can be programmed using the R-net PC Programmer. Within the PC
Programmer parameter tree, there is a branch called Omni. This branch