PG D
RIVES
T
ECHNOLOGY
O
MNI
– A
DVANCED
-P
ROGRAMMING
SK78813/5
If User Menu Position beeps are also set to occur,
they will be issued prior to the Profile identifier beeps.
5.6 Axis Identifier #
This can be set to issue a number of beeps corresponding to the actuator axis
number. The beeps are of a lower tone to the axis change beep and will occur
after that beep.
The beeps will occur regardless of whether Actuator Selection is set to SID or
Switch. In the latter case, there will be no beeps if Exit is the selected “axis”.
5.7 Position #
This sets the number of beeps that will occur when a new line (Position) in the
User Menu is highlighted. If Sequence operation is selected, the beeps will also
occur, but upon entry to the Mode that corresponds to the User Menu position.
If set to 0, then no beeps will occur for the position.
If a User Menu Position Type is set to List, all items
in the list are considered to be one position. See
example below.
To Next Page
Loading...
Need help?
General
