PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- P
ROGRAMMING
SK78813/5
2.1.8 Double Click
Two pneumatic operations made within the period set by the parameter
Double Click Time, mimic a short operation of the User Switch in Standby. This
parameter sets whether a double Soft or a double Hard command are
required.
The parameter can be set to either 2x Soft commands or 2x Hard commands
2.1.9 Double Click Time
This sets the period of time during which two pneumatic commands must be
detected, in order to be interpreted as a ‘double-click’.
The programmable range is between 0s and 2.5s in steps of 0.1s. (If set to 0s
no double-click facility will be supported).
2.1.10 Active Double Click
This parameter allows the user to test whether they can reproduce a pneumatic
double-click operation within the period set by Double Click Time.
2.2 Global – Scan Speed
This sets the scanning rate of the drive screen when using a Single Switch
Scanner Type SID.
2.3 Global - Sleep
2.3.1 Sleep 12V
This sets whether the 12V supply to the D-type connectors is present while the
Omni is asleep*.
There are two programmable options, On and Off.
If set to On, then the 12V supply will be present when the Omni is
asleep.
If set to Off, then the 12V supply will not be present when the Omni is
asleep.
To Next Page
Loading...
Need help?
General
