PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- P
ROGRAMMING
SK78813/5
2.9.4 User Menu Scroll
This sets the type of beep that occurs when scrolling through the User Menu,
Lights Menu and Settings Menu.
The programmable options are Off, Short and Long.
If set to Off, there will be no beep during scanning.
If set to Short, there will be a short beep each time the scanner moves
to a new line.
If set to Long, there will be a long beep each time the scanner moves
to a new line.
2.9.5 Profile Identifier #
This can be set to issue a number of beeps corresponding to the Profile
number. The beeps are of a lower tone to the Profile Change, Mode Change
and User Menu Entry beeps, and will occur after these.
Depending on how the Omni is set-up, the beeps will occur as below.
Menu operation with Drive Position Type set to Entry: no beep
sequence supported.
Menu operation with Drive Position Type set to List: beeps will occur
when a particular Profile is highlighted on the User Menu.
Menu operation with Drive Position Type set to Select: beeps will occur
when the Profile selection is changed on the User Menu.
Sequence operation with Drive Position Type set to Entry: no beep
sequence supported.
Sequence operation with Drive Position Type set to List: beeps will occur
when a particular Profile is entered.
Sequence operation with Drive Position Type set to Select: a Profile
Select screen, as shown below, will entered and the beeps will reflect
the selected Profile. Left and right SID movements will select the next
available Profiles and the corresponding number of beeps will occur.
To enter the selected Profile, operate the User Switch.
To Next Page
Loading...
Need help?
General
