PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- O
PERATION
SK78813/5
There are several standard R-net programming features that may be useful
when using this SID type. These include joystick throw, joystick orientation and
joystick deadband. Refer to the user guide for the programming method you
are using for further details of the available adjustments.
Standard control of seating movement is via Forward and Reverse commands,
and Left and Right commands will select a different seat axis for movement.
If required, it is possible to re-program the Omni to control the seating
movement in alternative ways. Refer to sections Actuator Selection and
Actuator Axes in the Programming chapter.
For latched operation using this SID type, refer to section Latched Operation.
4 Operation with Switch Type SIDs
Driving is via the SID’s Forward, Reverse, Left and Right switches, and the fifth
switch or User Switch is used to enter the User Menu or to sequence through the
other functions of the wheelchair.
There are several standard R-net programming features that may be useful
when using this SID type. These include joystick orientation. Refer to the user
guide for the programming method you are using for further details of the
available adjustments.
Standard control of seating movement is via Forward and Reverse commands,
and Left and Right commands will select a different seat axis for movement.
If required, it is possible to re-program the Omni to control the seating
movement in alternative ways. Refer to sections Actuator Selection and
Actuator Axes in the Programming chapter.
For latched operation using this SID type, refer to section Latched Operation.
5 Operation with 3-axis Proportional and Switch
Type SIDs (Head Arrays)
These types of SID contain a Forward/Reverse command, and Left and Right
commands, as well as a User Switch(es)*. Driving is via the Forward/Reverse, Left
and Right commands
To Next Page
Loading...
Need help?
General
