PG Drives Technology R-NET OMNI - 2 User Menu

PG D RIVES T ECHNOLOGY O MNI – S TANDARD - O PERATION
SK78813/5
42
2 User Menu
If the Menu method of control is being used, then an operation of the User
Switch will initiate the User Menu. A typical User Menu is shown below.
Forward and Reverse SID commands will change the highlighted line on the
menu. It is also possible to program an automatic scanning sequence, which
will highlight each line in turn. Refer to the Programming Chapter for further
details.
At the right hand end of each line, there will be either a > or a number
surrounded by < >, i.e. < 3 >
A > symbol indicates that a Right SID command, (or a User Switch operation
when using a Single Switch Scanner Type SID), will enter that function.
A <3> display indicates that Left and Right SID commands, (or a User Switch
operation when using a Single Switch Scanner Type SID), will change the
selection for that function.
The User Menu can provide the following functions.
Drive* > Will enter Drive Mode in the presently selected Profile.
x: Profile x** > Will enter Drive Mode in the indicated Profile.
Profile <x> Sets the Profile that is used the next time Drive Mode is
entered.