PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- I
NSTALLATION
SK78813/5
After the sequence has been performed and while the system remains
switched on, the Mode button can be used to sequence through all system
Modes and to return to OBP Mode. If the system is powered-down or there is no
OBP activity for 5 minutes, then the keypad sequence will need to be
performed again.
7.1.2 To enter OBP using the R-net Dongle:
• Turn off the control system.
• Connect the Dongle either between any of the system modules or
into any spare communications connector.
• Turn on the control system.
• Use the mode button to step to OBP mode.
While the Dongle remains connected, the Mode button can be used to
sequence through all system Modes and to return to OBP Mode.
7.2 Handheld Programming
From 2008, the Omni will be programmable via the R-net Handheld
Programmer.
7.3 PC Programming
The Omni can be programmed using the R-net PC Programmer. Refer to the
Programming chapter for more details.
8 Program the Omni to Match the SID
Fuller details on programming the Omni can be found in the Programming
chapter.
The Omni is compatible with six types of SID.
1. Joystick and User Switch
2. Five switch and User Switch
3. Three axis proportional and User Switch
To Next Page
Loading...
Need help?
General
