PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- P
ROGRAMMING
SK78813/5
A direction change occurs at the instant the User Switch is operated, provided
the parameter Double Click has been set to 0. If the User Switch is released and
a Forward/Reverse command is entered, then drive will commence in the
newly selected direction.
If the User Switch is not released and is held for time period set by the
programmable parameter, Switch Medium, then this is interpreted as a
conventional User Switch operation, i.e. the User Menu will be entered or the
other wheelchair functions would be sequenced. There will be no direction
toggle in this instance.
As with the other two methods, if the User Switch is operated for a period greater
than the time set by the programmable parameter, Switch Long, then the
Omni will go to sleep.
The programmable range is 0.5s to 5.0s in steps of 0.25s.
2.6.6 Switch Debounce
This sets the debounce time for the User Switch. Debounce is the period of time
the switch is operated continuously before a new condition is registered.
The programmable range is 30ms to 500ms in steps of 10ms.
2.6.7 Double Click
This sets the period of time during which two User Switch operations must be
detected, in order to be interpreted as a double-click.
The programmable range is 0s to 2.5s in steps of 0.1s
If set to 0s, then no double-click facility will be supported. This setting
should be used if accidental double-clicks are a problem.
If set to any other value, then this is the period that two User Switch
operations must be made, in order to be interpreted as a double-click.
2.6.8 Active Double Click
This parameter allows the user to set and test the Double Click speed.
This parameter is only available in OBP.
To Next Page
Loading...
Need help?
General
