PG Drives Technology R-NET OMNI User Manual

PG D RIVES T ECHNOLOGY O MNI – S TANDARD - I NSTALLATION
SK78813/5
19
If you are using the Omni with no other R-net Input
Modules and just one Specialty Input Device (SID),
you need only read this section.
1 Introduction
The Omni is a universal specialty controls interface that accepts signals from
many different types of SIDs and translates them into commands compatible
with the PG Drives Technology R-net control system.
The following diagrams show the Omni controls and connections. Full electrical
specifications are given in the Specifications Chapter.
This document must be read and understood by the healthcare professional
who is installing and configuring the Omni. If you are in any doubt contact PG
Drives Technology. The R-net Operating and Installation guide and the relevant
Input Device installation instructions should also be read.
It is possible to set up a control system so that it is
unsuitable for some users or even some vehicles. For
all of the above reasons it is important that you
contact PG Drives Technology if you have the
slightest doubts or if you need any advice on
programming.
Programming and diagnostics should only be
conducted by healthcare professionals with in-depth
knowledge of PG Drives Technology electronic control
systems. Incorrect programming could result in an
unsafe setup of a vehicle for a user. PG Drives
Technology accept no liability for any losses of any
kind if the programming of the control system is
altered from the factory preset values.

PG Drives Technology R-NET OMNI Specifications

General

Brand	PG Drives Technology
Model	R-NET OMNI
Category	Wheelchair
Language	English