PG D
RIVES
T
ECHNOLOGY
O
MNI
– S
TANDARD
- P
ROGRAMMING
SK78813/5
There are two programmable options, Drive and Menu.
If set to Drive, then a short operation of the User Switch in any non-Drive
Mode will return to the Drive Mode.
If set to Menu, then a short operation of the User Switch will bring up the
User Menu.
When using Single Switch Scanner Type SIDs this parameter will set the return
destination from a non-Drive Mode when the Exit option is highlighted and the
User Switch is operated.
2.7.3 Timeout to Menu
This sets the period of SID inactivity before the User Menu will appear.
The programmable range is 0s to 60s in steps of 1s.
If set to 0, then the User Menu cannot be entered using this method.
2.7.4 Menu Navigation
This parameter allows the user to invert the navigation direction of the User
Menu with their SID. This parameter is not adjustable with 3-axis type SIDs.
The programmable options are Normal and Invert.
If set to Normal, operations of the SID in the forwards direction will
navigate UP.
If set to Invert, operations of the SID in the forwards direction will
navigate DOWN.
2.7.5 Menu Scan Rate
This sets the scanning rate for the User Menu, Lights Menu and Settings Menu. If
User Control is set to Sequence, the scan rate will only be applicable in the
Lights and Settings menus.
The programmable range is between 0s and 10s in steps of 0.25s. (If set to 0s
no scanning is possible within menus).
To Next Page
Loading...
Need help?
General
