4: Repair Internal Assemblies — Front Chassis
140
Enabling Options
Once you enter the serial number and install software, you need to enable the options. If you enter the
options key incorrectly, the device’s options will not function.
To enable options:
1 From the Device Info menu, select Options Key. An alphanumeric menu is displayed, see Figure 95.
2 Enter the options key using the Navigation buttons to scroll through the letters and numbers. Press
the Menu Select button to complete each selection.
Select Cancel or Backspace to cancel a selection.
When the options key has been entered, the corresponding product options are displayed.
3 Select Done when you have finished entering the options key.
4 Repeat Step 2 through Step 3 for each options key.
5 Check the information on the screen to ensure it is correct.
CAUTION: Once you have entered the correct serial number, do not change it. If you clear or change the serial
number, the options are cleared and you must re-enter the correct serial number and the options key.
6 Run an Operational Check.
7 Review the Operational Check results to ensure all tests have passed.
See “Operational Check” on page 33.
8 Print the Device Info to ensure the product version and language are correct.
See “Device Information” on page 10.
Figure 95 Enabling Options
To Next Page
Loading...
