Philips HeartStart XL+ - Front Case Assembly

4: Repair Internal Assemblies — Front Chassis
150
Front Case Assembly
The front case replacement involves moving existing parts from the old case to the new.
 Preparation
1 Remove the Printer Assembly. See “Printer Assembly” on page 85.
2 Open and separate the case. See “Opening the Case” on page 87.
3 Remove the Rear Chassis Shelf. See “Rear Chassis Shelf” on page 93.
4 Remove the Rear Chassis. See “Front Chassis and Case Access” on page 134.
 Removal
1 If present, remove the SpO
2
PCA. See “SpO2 PCA” on page 126.
2 Remove the Measurement Module. See “Measurement Module and the Ports” on page 128.
3 Remove the Printer PCA. See “Printer PCA” on page 124.
4 Disassemble the Front Case:
a Remove the Front Chassis. See “Front Chassis Removal and Replacement” on page 142.
b Remove the Speaker Assembly. See “Speaker Assembly” on page 146.
c Remove the Therapy Port. See “Therapy Port” on page 119.
d Remove the Therapy Switch. See “Therapy Switch” on page 121.
e Remove the Display Assembly. See “Display Assembly” on page 149.
f Remove the HIF PCA. See “Human Interface PCA” on page 147.
g Remove the Therapy Buttons. See “Therapy Buttons” on page 148.
 Replacement
1 Reassemble the Front Case:
a Replace the Therapy Buttons. See “Therapy Buttons” on page 148.
b Replace the HIF PCA. See “Human Interface PCA” on page 147.
c Replace the Display Assembly. See “Display Assembly” on page 149.
d Replace the Therapy Switch. See “Therapy Switch” on page 121.
e Replace the Therapy Port. See “Therapy Port” on page 119.
f Replace the Speaker Assembly. See “Speaker Assembly” on page 146.
g Replace the Front Chassis. See “Front Chassis Removal and Replacement” on page 142.
2 Replace the Measurement Module. See “Measurement Module and the Ports” on page 128.
3 If present, replace the SpO
2
PCA. See “SpO2 PCA” on page 126.
4 Replace the Printer PCA. See “Printer PCA” on page 124.
5 Replace the Rear Chassis. See “Front Chassis and Case Access” on page 134.
6 Replace the Rear Chassis Shelf. See “Rear Chassis Shelf” on page 93.
7 Close the case. See “Closing the Case” on page 151
8 Replace the Printer. See “Printer Assembly” on page 85.
9 Replace the Handle. See “Handle Assembly” on page 78.
10 Apply the Control Panel label to the Front Case. See “Labels” on page 75.
 To Complete the Replacement:
 Run Performance Verification and Safety testing as described in the “Performance Verification”
chapter.