4: Repair External Assemblies
76
There is one instruction label set for each language (see “Instruction Label Sets” on page 180 for part
numbers). This set includes die-cut labels for:
• Battery Compartment label
• six Measurement Module label (marked Connector Block) for different options
• two Control Panel labels
• Rear I/O Connector label (marked Network Connector) for different options
• Therapy Port label (marked Patient Connector)
• four blank dots to cover screw holes on the blank paddle tray.
Branding Label
The branding label is affixed to the top of the device above the left side of the Display.
Primary Label
Primary label is not included in the label kit and shipped with the device. It lists the Serial Number and
the Options Key, and is affixed to the bottom of the device. See “Primary Label” on page 10.
Contact your local Response Center (see “Calling for Service” on page 68) if you replace the Rear Case
for the primary label replacement. Be prepared to provide the information from the old primary label.
Option Key Label
Option Key labels are shipped with upgrade kits and are affixed to the bottom of the device. Contact
your local Response Center (see “Calling for Service” on page 68) if you replace the Battery
Compartment Cover for the Option Key labels replacement. Be prepared to provide the information
from the old Option Key labels.
Removing and Replacing Labels
Preparation
Turn the device off and remove the battery and the AC power.
Removal
1 Start at one corner.
Using a sharp tool such as a utility knife, pick up one corner of the old label.
2 Peel up the label.
Peel the label up by pulling slowly and evenly on the loosened corner.
Replacement
1 Clean the surface:
a Remove any adhesive residue by rubbing the dry surface with your finger and “rolling up” the
adhesive residue.
Solvents are ineffective, as is scraping with a tool.
b Clean the surface with isopropyl alcohol. Allow it to dry.
2 Peel the new label off the backing.
Avoid touching the label adhesive, as this may prevent the label from bonding properly.
To Next Page
Loading...
