Closing the Case 4: Repair
151
Closing the Case
To close the Case:
1 Recheck the connections. Make sure all connections are fully seated and latched.
WARNING: Any connections that are not seated and latched properly during the device assembly may become
loose over time, causing devices to fail when in clinical use. Check all connections before closing the
device case.
2 If the Measurement Module is disassembled, then:
a Inspect the tubing gasket on the Measurement Module face plate, see Figure 89 on page 133.
b If the gasket is cracked, frayed, damaged, or there is a gap between the gasket ends, then replace
the gasket. See “Tubing Gasket Replacement” on page 96.
c Assemble the Measurement Module.
See “Measurement Module and the Ports” on page 128.
3 Assemble the Rear Chassis:
a If the Rear Chassis is removed, then replace the Rear Chassis.
See “Front Chassis and Case Access” on page 134.
b If the Rear Chassis is tilted or pivoted, then bring it into the upright position.
See “Tilting Rear Chassis” on page 91, “Pivoting Rear Chassis Downward” on page 108, or
“Pivoting Rear Chassis Upward” on page 122.
c If the Rear Chassis Shelf is removed, then replace the Shelf.
See “Rear Chassis Shelf” on page 93.
4 Position the device display side down, Capacitor to your left.
5 Ensure proper wire threading around the Battery PCA, see Figure 102:
a No wires are positioned in front of the Battery PCA.
b No wires are threaded in the area between the Battery PCA support pad tabs marked
to avoid
pinching between the lower Fan and Battery PCA support pad.
c The Network and ECG Out cables are threaded between the two tall standoffs to the right and
under the Battery PCA.
Figure 102 Rear Case Wire Threading
ECG Out
cable
Network
cable
the
standoffs
To Next Page
Loading...
