17 Enhancing Telemetry Monitoring with the Monitor
206
patient is also discharged (if configured), ensuring that the measurement data is erased before data
from the next patient appears. Always assign the telemetry transceiver before you start making
measurements.
NOTE When a direct connection is used: your monitor may be configured to automatically discharge the
patient either when the telemetry transceiver is disconnected or when another telemetry transceiver is
connected. Be aware that in the second case you must always connect the new telemetry transceiver
before you start making measurements, otherwise the measured data will be erased by the discharge
when you connect the new telemetry transceiver.
To Next Page
Loading...
Need help?
General
