4Alarms Alarm Limits
46
Viewing Individual Alarm Limits
You can usually see the alarm limits set for each measurement next to the
measurement numeric on the main screen.
If your monitor is not configured to show the alarm limits next to the numeric,
you can see them in the appropriate measurement setup menu. Select the
measurement numeric to enter the menu and check the limits.
Viewing All Alarm Limits
The Alarm Limits overview window lists the currently set alarm limits for all measurements. If an
Apnea alarm delay time is set, this is also shown. The ALARMS OFF symbol is shown beside the
measurement label of any measurement whose alarm switched off.
To open the Alarm Limits window, either select any alarm field to open the Alarm
Messages window, then select the Alarm Limits pop-up key, or select the Alarm
Limits SmartKey, if configured.
85
120
50
HR
Alarm limits
1
2
3
Alarm Limits
ST-V4
ST-V5
ST-V6
SpO
2
Pulse (SpO
2
)
ABPs
PAPd
awRR
NBPs
Apnea Time
Off
sec
To Next Page
Loading...
Need help?
General
