ABL77 Service Manual Chapter 5: Dismantling
Overview, Continued
Equipment
required
The following items are required for carrying out these procedures.
• 1/16" Ball Point Allen wrench, REF: 920-722
• 1/4” nut driver, REF: 920-728
• 5/16" nut driver, REF: 920-727
• 5/16” open-end wrench, REF: 920-726
• 5/64" Ball point Allen wrench, REF: 920-721
• 7/64" Ball point Allen wrench, REF: 920-723
• Flat head screwdriver
• Small flathead screwdriver for adjusting the calibration settings
• Phillips head screwdriver
• Needle nose pliers
• Scissors or equivalent trimming tool
• Index card or equivalent to block the opto sensor
• Deionized water (or sterile water)
• Soft cloth, gauze or other absorbent material
• 3cc disposable syringe with luer adapter (can be found in the Sample Path
Obstruction Tool kit, REF: 905-674)
Rev. F 5-3
To Next Page
