Chapter 5: Dismantling ABL77 Service Manual
Printer Module
Introduction
This procedure describes the process for removing the printer module from the
lower module.
Removing the
printer module
Follow these steps to remove the printer module as shown in the following figures.
Step Action
1.
Open the printer door. Remove the paper roll if necessary.
2.
Loosen the two panel screws on either side of the printer module.
3.
Slide the printer module out and disconnect the three cables attached
to the back.
Figure 5-7
Figure 5-8
Part Function
1. Printer panel screws
2. Printer data cable connector
3. Printer power connectors
Continued on next page
5-14 Rev. F
To Next Page
Loading...
