ABL77 Service Manual Chapter 7: Re-Assembly
Printer Module
Introduction
Follow these steps for attaching the printer module to the lower module (see Figure
7-21).
Step Action
1.
Open the printer door.
2.
Attach the printer cables to the rear of the printer module.
3.
Slide the printer module into the printer chassis and hand-tighten the
two panel screws on either side of the printer module.
Figure 7-21
Part Function
1. Printer panel screws
2. Printer data cable connection
3. Printer power cable connections
Rev. F 7-35
To Next Page
Loading...
