Chapter 6: Replacements ABL77 Service Manual
Backlight Inverter Cable
Backlight
inverter cable
Follow these steps to replace the backlight inverter cable.
Step Action
1.
Remove the electronics module. One end of the backlight inverter
cable will be disconnected when the upper module is removed.
2.
Remove the analog board.
3.
Disconnect the old backlight inverter cable from the LCD adapter
board.
4. Connect the new backlight inverter cable (item 1 in figure 6-23) to the
LCD adapter board with the two wires away from the front of the
electronics module.
Figure 6-23
Continued on next page
6-40 Rev. F
To Next Page
Loading...
