ABL77 Service Manual Chapter 7: Re-Assembly
7. Re-Assembly
Overview
Introduction
This chapter describes the procedures for re-assembling the analyzer after repair /
replacement and testing of the analyzer.
CAUTION: Follow legal requirements and local rules for safe work practices with
chemicals.
WARNING/
CAUTION:
CAUTION: Working with blood gas analyzers may result in contact with blood
remnants and with harsh disinfectants. During the various procedures wear suitable
protection gear (gloves, face protection, and protective body clothing), following
legal requirements and local rules for safe work practices.
CAUTION: The gloves must be free of pin holes and preferably be puncture
resistant. Please consult the glove manufacturer for further information.
CAUTION: If contaminated material comes into contact with any lesion on the
body, seek medical advice.
IMPORTANT: Always establish an ESD protected area before removing a module
from the analyzer or exposing electronics to prevent damage of the electronics.
Important
IMPORTANT: Some flat cable connectors are equipped with a locking device.
Always press on the side before pulling the connector to avoid damage.
IMPORTANT: Never use sharp tools for handling tubing to avoid damage.
Continued on next page
Rev. F 7-1
To Next Page
Loading...
Need help?
General
