R&S FSPN - Page 192

Data Management
R&S
®
FSPN
192User Manual 1179.4363.02 ─ 01
Remote command:
MMEMory:COMMent on page 452
File Explorer
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
File Type
Determines whether the global instrument settings with all "Channel" s are stored or
recalled, or the current "Channel" settings only.
Items:
Defines which data and settings are stored or are recalled. Depending on the "File
Type" , either channels only, or global settings are available. Which items are available
also depends on the installed options (see also Chapter 8.2.2.1, "Stored Data Types",
on page 189).
Remote command:
MMEMory:SELect[:ITEM]:ALL on page 456
MMEMory:SELect[:ITEM]:DEFault on page 457
MMEMory:SELect[:ITEM]:NONE on page 457
MMEMory:SELect[:ITEM]:HWSettings on page 457
MMEMory:SELect[:ITEM]:LINes:ALL on page 457
MMEMory:SELect[:ITEM]:SGRam on page 458
MMEMory:SELect[:ITEM]:TRACe<1...3>[:ACTive] on page 458
MMEMory:SELect[:ITEM]:TRANsducer:ALL on page 458
Save File
Saves the settings file with the defined filename.
Remote command:
MMEMory:STORe<1|2>:STATe on page 461
MMEMory:STORe<1|2>:STATe:NEXT on page 461
Recall in New Channel / Recall in Current Channel
Restores the instrument settings as saved in the selected settings file. If the settings
file contains settings for a specific "Channel" only, select "Recall in New Channel" to
activate a new channel with the stored settings. Select "Recall in Current Channel" to
replace the current "Channel" settings.
Note: After you use the "Recall" function, the history of previous actions is deleted, i.e.
any actions performed previously cannot be undone or redone using the [UNDO/
REDO] keys.
Remote command:
MMEMory:LOAD:STATe on page 460
8.2.2.4 Startup Recall Settings
Access: "Open" icon in the toolbar > "Startup Recall"
Storing and Recalling Instrument Settings and Measurement Data