R&S FSPN - Page 368

Remote Control
R&S
®
FSPN
368User Manual 1179.4363.02 ─ 01
11.6.6.2 Residual Calculation Configuration
For manual operation, see Chapter 6.5.4, "Integrated Measurement Configuration",
on page 116.
CALCulate<n>[:RANGe<j>]:EVALuation:STARt.................................................................368
CALCulate<n>[:RANGe<j>]:EVALuation:STOP................................................................. 368
CALCulate<n>[:RANGe<j>]:EVALuation:TRACe............................................................... 369
CALCulate<n>[:RANGe<j>]:EVALuation[:STATe]...............................................................369
CALCulate<n>[:RANGe<j>]:EVALuation:WEIGhting.......................................................... 370
[SENSe:]CORRection:WEIGhting:COMMent.....................................................................370
[SENSe:]CORRection:WEIGhting:DATA........................................................................... 370
[SENSe:]CORRection:WEIGhting:DELete........................................................................ 370
[SENSe:]CORRection:WEIGhting:NAME..........................................................................371
[SENSe:]CORRection:WEIGhting:SELect.........................................................................371
CALCulate<n>[:RANGe<j>]:EVALuation:STARt <Frequency>
This command defines the start frequency of a custom integration range for residual
effects calculation.
Prerequisites for this command
●
Turn off integration over the complete measurement range (CALCulate<n>[:
RANGe<j>]:EVALuation[:STATe]).
Suffix:
<n>
.
Window
<j> Integration range
Parameters:
<Frequency> <numeric value>
Range: Depends on the measurement range.
*RST: 1 MHz
Default unit: Hz
Example: See CALCulate<n>[:RANGe<j>]:EVALuation[:STATe].
Manual operation: See "Defining the integration range" on page 117
CALCulate<n>[:RANGe<j>]:EVALuation:STOP <Frequency>
This command defines the stop frequency of a custom integration range for residual
effects calculation.
Prerequisites for this command
●
Turn off integration over the complete measurement range (CALCulate<n>[:
RANGe<j>]:EVALuation[:STATe]).
Suffix:
<n>
.
Window
<j> Integration range
Common Measurement Settings