REXROTH IndraDrive C User Manual

Rexroth IndraDrive Introduction 1-13
DOK-INDRV*-SYSTEM*****-PR02-EN-P
Control Section
The control section is a separate component that is plugged into the
power section; it consists of
• the basic control section circuit board with interfaces
• the optional modules in the case of configurable control sections
The optional modules are included on the basic control section circuit
board in optional slots. As an example, the figure below illustrates optional
slots Option1...4.
Fig. 1-12: Optional slots on control section
The drive controller is supplied complete with factory-installed (possibly
configured) control section.
Note: The control section may only be replaced by qualified
personnel.

REXROTH IndraDrive C Specifications

General

Protection Class	IP20
Voltage Range	200 V to 480 V
Input Voltage	200 to 480 VAC
Control Modes	Speed, Torque, Position
Communication Interfaces	PROFIBUS, CANopen, Ethernet
Feedback Systems	Resolver, incremental encoder, absolute encoder