Rexroth IndraDrive Configuration of the Drive System Rexroth IndraDrive 6-21
DOK-INDRV*-SYSTEM*****-PR02-EN-P
Note: Operating other encoder systems than the ones listed above
requires detailed control of the technical data of the encoder
system used and the interface specification of the control
section. In particular, take the supply voltage data into
account.
6.5 Combination with Other Rexroth Components
Combination with Components of the Control Range
Rexroth IndraControl V
Small Operator Terminals VCP
For comfortable operation of the Rexroth IndraDrive drive system with the
IndraControl V control range there are small operator terminals of the
VCP series available.
The small operator terminals VCP 01, VCP 02, VCP 05, VCP 08, VCP 20
and VCP 25 are suited for control cabinet mounting and are operated via
the serial interface RS232 (X2) of the control sections.
Note: The optional equipment "C" and "S" that can be plugged in is
similar to the VCP 01 small operator terminal. In the Project
Planning Manual of the control sections the hardware of the
options is described as comfort control panel ("C") or standard
control panel ("S"). The function of the control panels is
described in the Functional Description of the firmware.
Simultaneous operation of VCP small operator terminals and
standard control panels or comfort control panels is allowed.
Combinations with Components of the Drive Range Diax04
Encoder Junction DGA
in preparation
To Next Page
Loading...
Need help?
General
