Ricoh PRO C7210

1.SC Codes
114
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC586-33
D
Invert/Exit Motor
SC586-40
D
Decurl Motor
SC586-41
D
Decurler Paper Transport Motor
 Detection period: 100 ms
 SC if error detected 2 times consecutively
 Driver overheating protection
 Stepper Motor harness broken.
 Stepper Motor shorted.
 Harness disconnected.
 Reconnect the connectors.
 Replace the Stepper Motor.
 Replace the harnesses.
 Replace the PCB.
Replace the following boards.
 -10 to 15: PFB
 -20 to 25: DRB
 -30 to 33: TDCU
 -40, -41: DDRB
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC587-
00
C
Main Unit Temperature Sensor Error
When errors are detected 3 times consecutively during 1-minute periods, it is
judged that an error has occurred and SC is issued.
 -10 degrees or lower is detected for the measurement temperature of the
main unit temperature sensor.
 80 degrees or higher is detected for the measurement temperature of the
main unit temperature sensor.
 Connector disconnected or broken
 Thermistor defective.
 Connector disconnected or broken
Reconnect the connector.
 Sensor defective
Replace the sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC589-
01
D
Toner Bottle Motor Error (Driver Error Detection):K