Ricoh PRO C7210

1.SC Codes
115
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC589-
02
D
Toner Bottle Motor Error (Driver Error Detection):C
SC589-
03
D
Toner Bottle Motor Error (Driver Error Detection):M
SC589-
04
D
Toner Bottle Motor Error (Driver Error Detection):Y
The driver error detection signal for the Toner Bottle Cap Motor and Toner Bottle
Motor errors is monitored at 100ms intervals. When errors are detected 3 times
consecutively, it is judged that an error has occurred and SC is issued. It is not
possible to differentiate between Toner Bottle Cap Motor and Toner Bottle Motor
errors.
 175 degrees (typical) or higher
 Specified current is 4us (typical) or higher
 When an error is detected at 175 degrees (typical) or higher: automatic restart
at 150 degrees (typical) or lower
 When an error is detected at specified current of 4us (typical) or higher: restart
by switching 24V or 5V OFF/ON
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC590-
00
D
Exit Motor Error
1000ms after starting the motor, “Lock Signal: Low” was not detected 10 times
consecutively during the time until the motor stop signal is received.
 Motor connector disconnected
 Abnormal increase in the Exit Roller torque (overload due to the bearing lock,
etc.)
 Motor driver malfunctioning
 Exit Motor malfunctioning
 Reconnect the motor connector
 Eliminate the cause of overload in the exit unit.
 Replace the motor driver.
 Replace the Exit Motor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC593-00
D
Decurler Over Limit
Decurler Limit Sensor is detected as on.
 HP misdetection