Ricoh PRO C7210

1.SC Codes
186
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Check the LE Stopper Motor/LE Stopper HP Sensor connection.
 Replace the LE Stopper Motor/LE Stopper HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
40
B
Stacker 1 (Upstream): Tray Lift Motor Error
SC731-
40
B
Stacker 2 (Downstream): Tray Lift Motor Error
 When lowering, the paper height sensor continues to detect paper even after
the time limit passes. (The first time: jam display, the second time: SC)
 When rising, the paper height sensor does not detect the upper surface of
paper even after the time limit passes. (The first time: jam display, the second
time: SC)
 The tray high limit SW, tray low limit SW and door safety SW is detected.
(This SC issues immediately at 1st occurrence)
 Motor defective
 Connecter disconnected
 Overload
 Paper Height Sensor defective
 Check the Tray Lift Motor/Paper Height Sensor connection.
 Replace the Tray Lift Motor/Paper Height Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
50
B
Stacker 1 (Upstream): Shutter Motor Error
SC731-
50
B
Stacker 2 (Downstream): Shutter Motor Error
 When the shutter moves to the home position, the home position was not
detected within specified number of pulses(p0 pulse). (The first time: jam
display, the second time: SC)
 When the shutter moves from the home position, the home position was still
detected after specified number of pulses (p1 pulse). (The first time: jam
display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Shutter motor defective
 Shutter connector disconnected/damaged
 Shutter motor overloaded