Ricoh PRO C7210

1.SC Codes
185
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
34
B
Stacker 1 (Upstream): Sub Jogger Motor Error
SC731-
34
B
Stacker 2 (Downstream): Sub Jogger Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Motor driver overcurrent
 Motor driver overheat detected
 Check the Sub Jogger Motor/Sub Jogger HP Sensor connection.
 Replace the Sub Jogger Motor/Sub Jogger HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
35
B
Stacker 1 (Upstream): LE Stopper Motor Error
SC731-
35
B
Stacker 2 (Downstream): LE Stopper Motor Error
 When lowering, the paper height sensor continues to detect paper even after
the time limit passes.(The first time: jam display, the second time: SC)
 When rising, the paper height sensor does not detect the upper surface of
paper even after the time limit passes.(The first time: jam display, the second
time: SC)
 The tray high limit SW, tray low limit SW and door safety SW is detected.
(This SC issues immediately at 1st occurrence).
 Motor defective
 Connecter disconnected
 Overload
 Paper Height Sensor defective