Ricoh PRO C7210 - Page 188

1.SC Codes
184
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
32
B
Stacker 1 (Upstream): Main Jogger Rear Fence Motor Error
SC731-
32
B
Stacker 2 (Downstream): Main Jogger Rear Fence Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Motor driver overcurrent
 Motor driver overheat detected
 Check the Main Jogger Rear Fence Motor/Rear Fence HP Sensor
connection.
 Replace the Main Jogger Rear Fence Motor/Rear Fence HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
33
B
Stacker 1 (Upstream): Main Jogger Fence Retraction Motor Error
SC731-
33
B
Stacker 2 (Downstream): Main Jogger Fence Retraction Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Motor driver overcurrent
 Motor driver overheat detected
 Check the Main Jogger Fence Retraction Motor/Jogger Fence Retraction HP
Sensor connection.
 Replace the Main Jogger Fence Retraction Motor/Jogger Fence Retraction