Ricoh PRO C7210

1.SC Codes
183
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
30
SC731-
30
B
Stacker 2 (Downstream): Shift Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Motor driver overcurrent
 Motor driver overheat detected
 Check the Shift Motor/Shift HP Sensor connection.
 Replace the Shift Motor/Shift HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC730-
31
B
Stacker 1 (Upstream): Main Jogger Front Fence Motor Error
SC731-
31
B
Stacker 2 (Downstream): Main Jogger Front Fence Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Motor driver overcurrent
 Motor driver overheat detected
 Check the Main Jogger Front Fence Motor/Front Fence HP Sensor
connection.
 Replace the Main Jogger Front Fence Motor/Front Fence HP Sensor.