Ricoh PRO C7210

1.SC Codes
29
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
05
The image transfer of the corresponding color from the IPU to the LDB did not
work normally.
 IPU defective (LD ASIC failure)
 USB cable between IPU and LDB defective (disconnection, contact failure)
 LDB defective (LD ASIC failure)
1. Cycle the main power switch off/on.
2. Reconnect the USB cable between LDB and IPU.
3. Replace the USB cable.
4. Replace the IPU
5. Replace the laser unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC276-01
D
Microcomputer communication error: 1st
SC276-02
D
Microcomputer communication error: 2st
SC276-03
D
Microcomputer communication error: 3st
SC276-04
D
Microcomputer communication error: 4st
SC276-05
D
Microcomputer communication error: 5st
The LDB (microcomputer) of the corresponding color is not working normally.
 LDB defective (LD ASIC or microcomputer failure)
 Cycle the main power switch off/on.
 Replace the laser unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC285-
00
D
MUSIC error
The MUSIC pattern reading failed 4 times while the machine is turned ON.
When the color shift amount (sub scan registration, main scan registration, main
scan magnification ratio, main scan left/right magnification ratio, or skew) is equal
to or greater than the specified value, it is judged to be a failure.
 Speed of ITB or drum rotation abnormal
 LDB defective (LD ASIC failure)
 Pattern density defection
 Belt flawed or smudged
 TM sensor smudged or defective
 Skew Motor drive error
 The MUSIC pattern is misaligned with respect to the TM/P sensor.