Ricoh PRO C7210

1.SC Codes
354
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
30
B
Ring Binder: Paddle roller HP error
 When moving to the home position, the sensor could not detect the
component at the home position within the prescribed time (400 pulses). The
first occurrence triggers a jam, the second an SC code.
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (400 ms). The first occurrence triggers a
jam, the second an SC code.
 Paddle roller lift motor (M603) defective
 Motor overloaded
 Connector loose, broken, defective
 Paddle roller HP sensor defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
31
B
Ring Binder: Jogger fence 1 error
 When moving to the home position, the sensor could not detect the
component at the home position within the prescribed time (400 pulses). The
first occurrence triggers a jam, the second an SC code.
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (400 ms). The first occurrence triggers a
jam, the second an SC code.
 Jog fence 1 motor (M604) defective
 Connector loose, broken, defective
 Motor overload
 Side fence 1 HP sensor (S601) defective
 Replace the motor