Ricoh PRO C7210

1.SC Codes
359
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
1500 ms (1st detection signals a jam, 2nd detection issues this SC code)
 Clamp unit motor (M701) defective
 Connector loose, broken, defective
 Motor overload
 Bind timing sensor (S702) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
46
B
Ring Binder: Clamp unit HP error
 At initialization or during ring binding, the unit did not arrive at home position
within the prescribed time (1500 ms) (1st detection triggers a jam alert, 2nd
detection issues this SC code).
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (1500 ms) (1st detection triggers a jam
alert, 2nd detection issues this SC code).
 Clamp unit motor (M701) defective
 Connector loose, broken, defective
 Motor overload
 Clamp unit HP sensor (S701) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
47
B
Ring Binder: Spine alignment error
During alignment a home position timeout (400 ms) occurred twice during
movement of the tip of the alignment pin (2nd attempt was within an additional 400
ms).
 Alignment pin motor (M602) defective
 Connector loose, broken, defective
 Alignment pin HP sensor (S604) defective