Ricoh PRO C7210

1.SC Codes
360
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Alignment pin up sensor (S610) defective
 Jog mechanism defective
 Punch defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-48
B
Ring Binder: Binder unit not detected
Binder unit was not detected at initialization before operation.
 Connector loose, broken, defective
 Drawer connector defective
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
50
B
Ring Binder: Output belt rotation error
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (800 pulses). The first occurrence triggers
a jam, the second an SC code.
 The sensor could not detect the component within the prescribed time (2300
pulses). The first occurrence triggers a jam, the second an SC code.
 Output belt rotation motor (M403) defective
 Connector loose, broken, defective
 Motor overload
 Output belt rotation HP sensor (S403) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
B
Ring Binder: Output belt 1 HP error