Ricoh PRO C7210

1.SC Codes
36
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
machine off/on to return from SC status.
 Reset or replace the toner bottle.
 Replace the toner bottle motor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC336-
01
D
Developer Set Error (K)
SC336-
02
D
Developer Set Error (C)
SC336-
03
D
Developer Set Error (M)
SC336-
04
D
Developer Set Error (Y)
SC336-
05
D
Developer Set Error (S)
When the TD sensor control voltage (Vtcnt) is 4.3V, the TD sensor output (Vt) is
less than 0.7V.
Details:
When executing TD sensor initialization (SP3-030), the machine checks the
development unit for the presence of developer. If the error condition is detected at
this point, the machine determines that there is no developer and issues the SC.
 There is an extremely low amount of developer.
 Replace the developer.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC348-
01
D
Toner supply error (K) : Sub-hopper 1 (front)
SC348-
02
D
Toner supply error (C) : Sub-hopper 1 (front)
SC348-
03
D
Toner supply error (M) : Sub-hopper 1 (front)
SC348-
04
D
Toner supply error (Y) : Sub-hopper 1 (front)
SC348-
05
D
Toner supply error (S) : Sub-hopper 1 (front)
Error occurs if ID Pattern adhesion (SP3-300-***) < Lower limit threshold (SP3-
301-***), and Toner Supply Clutch cumulative time (SP3-301-***) > Feed counter