Part C - Operation cobas p 512
3-20 Operator's Manual - Version 1.6 - 10/2015
3.3.9.4 Racks
Example: Roche PVT rack
Racks are available in different sizes and shapes. Roche PVT racks have been designed
especially for the system. Loading and unloading the system with these racks is very easy. In
order to fasten the rack onto its tray, it must be engaged from above into pins, pushed
forward against a spring, lowered and snapped in place.
Figure 3-13: Roche PVT rack
3.3.9.5 Clamp down the racks with the clamping rail.
A clamping rail is used for fastening the racks in the rack trays.
Figure 3-14: Using the clamping rail
1. Arrange the clamping rails to the right side of the rack trays.
2. Lift the clamping rail and push it between the racks and the rack trays.
To Next Page
Loading...