Rohde & Schwarz R&S SGS100A - Page 64

Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
64User Manual 1173.9105.02 ─ 13
Figure 8-1: Mapping file example
Tip: In a remote control application program, address the instruments by their symbolic
names and retrieve the remain required settings from the mapping file. This workflow is
especially useful for frequent exchange of instruments.
Remote command:
:INSTruments:MAPPing:FILE on page 87
Scan LAN instruments with host name prefix
Sets the prefix the searched host names begin with. Use this function to limit the
amount of the searched instruments and to speed up the scan process.
For example, set this field to "RsSGS, RsSGU, RsSGT", if you want to search for all
available instruments.
If your instrument is not listed in the "Avalable Instruments" dialog, leave the field
empty and execute another scan.
Remote command:
:INSTruments:SCAN:HNPRefix on page 88
Scan Subnet
Activates scanning of the subnet.
If you click "Scan" the scanning procedure includes instruments detected in the subnet.
Remote command:
:INSTruments:SCAN:SNET[:STATe] on page 89
IP Address
Sets the IP address with the subnet.
Remote command:
:INSTruments:SCAN:SNET:IPADdress on page 88
Prefix Length
Sets the prefix length in bits.
Remote command:
:INSTruments:SCAN:SNET:PLENgth on page 89
Operating menu and toolbar