COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec. 03, 2021Sept.
30, 2021
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Risk of electric shocks
WARNING: To avoid personal injury or equipment damage, disconnect the power cable
(TWO cables in case of redundant power supply) before performing any technical support.
Disconnection, all power plugs
Explosive atmosphere
WARNING: Do not operate the equipment in the presence of flammable gases or fumes.
Operation of any electrical equipment in such an environment constitutes a definite safety
hazard.
Battery
Risk of explosion if battery replaced with an incorrect type. Dispose of used batteries
according to the instructions.
Installation
Installation in a rack: This unit must be used in a 19” rack mount cabinet only
LIFTING THE UNIT: IF THIS APPARATUS WEIGHS OVER 25KGS, SO TAKE EXTREME CARE WHEN
LIFTING OR MOVING THIS UNIT. WE RECOMMEND THAT TWO PEOPLE ARE AVAILABLE TO LIFT THIS
UNIT.
VENTILATION: DO NOT BLOCK ANY VENTILATION OPENINGS. ENSURE THAT THE PRODUCT
VENTILATION IS NOT IMPEDED.
Cleaning
To clean the equipment, use a damp cloth without detergent. Make sure that the equipment
is not connected to the mains (cable disconnected).
To Next Page
Loading...