SATO S84NX - Page 168

[Advanced]
168
Standard/Left-Hand Type Opposite/Right-Hand Type
(1) Feed direction
(2) Offset position (backfeed/stop position for
Dispense operation)
(3) Pitch position (leading edge of media position
that decides the vertical print position)
(1) Feed direction
(2) Offset position (backfeed/stop position for
Dispense operation)
(3) Pitch position (leading edge of media position
that decides the vertical print position)
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
-392 to 0 to 392 dots -392 to 0 to 392 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
-588 to 0 to 588 dots -588 to 0 to 588 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
-1176 to 0 to 1176 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Darkness Adjust]
Fine tune the print darkness.
The setting range is from 0 to 99.