SATO S84NX - Page 170

[Advanced]
170
The actual media feed amount is the value of [Offset] + [Finisher Feed].
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
0 to 2040 dots 0 to 2040 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
0 to 3060 dots 0 to 3060 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
0 to 6120 dots -
• When [Printing Mode] is set to [Use Ribbon], the length of label backfeed needs to be
under 30 mm (1.18"). If it is over 30 mm (1.18"), the end of the ribbon may be falsely
detected.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• A message prompting you to restart the product will appear on the Online/Offline
screen if you have made any changes. In such a case, reboot the product to apply the
settings.
[Feed Speed]
Set the speed that media feeds.
The setting items are as follows:
[Sync with Print Speed]
The feed speed setting is set to the same value as the print speed setting.
The options are as follows:
Enabled
The feed speed setting is linked with the setting in the [Printing] > [Speed] menu.
Disabled
Manually set the feed speed in [Feed Speed].
[Feed Speed]
Manually set the feed speed.
Can be set if [Sync with Print Speed] is disabled.
The setting range is as follows: