SATO S84NX - Page 171

171
Resolution S84NX S86NX
203 dpi (8 dots/mm) 4 to 16 ips (inches/sec) (101.6 to
406.4 mm/sec)
4 to 14 ips (inches/sec) (101.6 to
355.6 mm/sec)
305 dpi (12 dots/mm) 4 to 14 ips (inches/sec) (101.6 to
355.6 mm/sec)
4 to 12 ips (inches/sec) (101.6 to
304.8 mm/sec)
609 dpi (24 dots/mm) 2 to 6 ips (inches/sec) (50.8 to
152.4 mm/sec)
-
• Can be specified only for speeds lower than the value set in the [Speed] menu.
• If [Enabled] is selected in the [Micro Label Print Mode] menu, the feed speed has a
maximum of 4 ips (inches/second).
[Backfeed Speed]
Set the backfeed speed.
The setting range of the backfeed speed is from 2 to 8 ips (inches/sec) (50.8 to 203.2 mm/sec)
regardless of the printing resolution.
[Paper End]
Select the sensor for sensing the paper end and adjust the detection distance of the paper end.
The setting items are as follows:
[Sensor Type]
Set the sensor for detecting the paper end.
The options are as follows:
Using I-mark
Use the I-mark sensor (reflective type) to detect the paper end.
The detection distance is 15 mm (0.59") (fixed position).
Using Gap
Use the Gap sensor (transmissive type) to detect the paper end.
The detection distance can be set in the range of 15 mm to 400 mm (0.59" to 15.75") in [Paper
End Distance].
None
Disable the paper end detection.
[Paper End Distance]
Adjust the detection distance of the paper end when [Sensor Type] is set to [Using Gap].
Available only if you have selected [Using Gap] in the [Sensor Type] menu.
The setting range is as follows: