SATO S84NX - Page 172

[Advanced]
172
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
120 to 3200 dots 120 to 3200 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
180 to 4800 dots 180 to 4800 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
360 to 9600 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Head Base Position] (S84NX Only)
Set the position used for the base reference point for printing.
The options are as follows:
Standard
Print with a standard base reference point.
Left-justify
Move the print base reference point 2 mm (0.08") toward the rear (when facing the product).
• A message prompting you to restart the product will appear on the Online/Offline
screen if you have made any changes. In such a case, reboot the product to apply the
settings.
[Prioritize]
For product settings, set whether to prioritize the settings that are done through the product or through
commands.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings that are done through the product.
[Reprint]
Enable or disable the reprint function.