SATO S84NX - Page 173

173
The options are as follows:
Enabled
Enable the reprint function.
Disabled
Disable the reprint function.
If you have selected [Enabled] in [Reprint], you can press the button ([REPRINT]) on the
Online screen to print the previous data again.
• The previous data will be lost if you power off the product.
[Print End Position]
Adjust the media stop position when the [Sensor Type] is set to [None]. This adjustment also sets the
blank amount from the media stop position.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
0 to 20000 dots 0 to 20000 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
0 to 18000 dots 0 to 18000 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
0 to 9600 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Calendar Setting Mode]
Set the settings for the calendar function.
The setting items are as follows:
[Calendar Reprint]
Set whether to update the date and time when doing reprinting with the reprint operation.
• With the reprint operation done if printing is stopped because an error occurs, the date
and time are updated even if this setting is [Disabled].
The options are as follows: